Soft fascia
Damaged fascia is replaced with primed wood or PVC with sealed joints and ends.
Exterior Services
Fascia Repair Randolph, NJ
A roofer in Randolph can repair or replace rotted fascia boards, reattach sagging gutters and fix the drip edge that keeps water off the wood, once the source of the water is found. Call (973) 858-1826 to reach a local roofer.
When a fascia board goes soft, the cause is almost always water running down the back of the gutter instead of into it. Clogged or poorly pitched gutters spill over the back, and a roof edge with no drip edge sends water straight down the fascia. Once the wood is soft, gutter hangers pull loose and the gutter sags or tips forward.
Fascia damage does not stay in the fascia for long. Left alone, the rot moves into the rafter ends and the edge of the roof deck, which turns a trim repair into structural work. Metal-wrapped fascia is especially tricky because water can get trapped behind the wrap and rot the wood out of sight.
A few observations make the first conversation more useful. Note where paint is peeling, where gutters sag or have pulled away, and whether water pours over the gutter in heavy rain. It also helps to know the fascia material and whether the gutters are original to the house.
Many fascia repair calls in Randolph also turn up a need for soffit repair or gutter installation.
Looking for Randolph fascia repair? Call (973) 858-1826 to talk to a local roofer.
Call nowThe process
What happens during a fascia repair
Good fascia work deals with the roof edge, the gutter and the board together.
Find the water path
The visit starts with where the water comes from, usually a missing drip edge, a clogged gutter or a gutter with the wrong slope. Probing along the board shows where the rot starts and stops.
Remove the gutter
The gutter section over the damage is unhooked and set aside so the fascia can come off. Old spikes and loose hangers are not reused.
Repair the framing
Soft rafter tails are cut back and sistered with new lumber, and rotted decking at the edge is replaced. Skipping it is the most common reason fascia fails twice.
Fit the board
The new board is fastened to the rafter tails with corrosion-resistant nails or screws, with tight joints at the corners. End grain is sealed so it does not soak up water.
Reset the drip edge
The metal drip edge at the roof edge is adjusted so runoff lands in the gutter, not behind it. It is a small part that does most of the work.
Reattach gutters
The gutter goes back up with new hidden hangers screwed into solid wood, pitched toward the downspout. Wood fascia gets a finish coat of paint.
What is included
What fascia repair covers
Framing repair
Rotted rafter ends behind the fascia are sistered or rebuilt before the fascia goes back on.
Fascia wrapping
Metal wrap can be added over new or sound fascia once any rot is gone.
Edge flashing
Missing or bent drip edge is replaced at the roof edge which stops the rot from coming back.
Gutter reattachment
Sagging gutters are rehung on solid fascia with new hangers at the right slope.
Related service
Fascia Board Replacement Randolph, NJ
When rot runs along most of a wall, or the boards are split and warped end to end, replacing the full run of fascia is the cleaner fix. The gutters come down, the old boards come off and the rafter tails behind them are checked before new boards go up. The choice of material affects upkeep, since wood needs paint while PVC and wrapped boards do not.
For many Randolph homes it makes sense to replace fascia while the gutters are off for replacement anyway. Make sure rotted boards are removed, not covered. Also ask about the size of the new boards, since fascia that is too narrow can leave gaps at the soffit and gutter.
Related service
Fascia Board Repair Randolph, NJ
When rot is confined to short stretches, the damaged part of the board can be cut out and a new piece scarfed in. A scarf joint, cut at an angle and glued and fastened, blends the new piece into the old board and sheds water better than a square butt joint. Very small areas of surface rot can sometimes be treated with a wood consolidant and exterior filler, then primed and painted.
Patching a fascia board in Randolph without fixing the gutter or drip edge above it just buys a season or two. The cause is often a leaking gutter corner or a downspout that backs up. Done right, the repair is hard to spot once painted.
Local help
Fascia Repair Near Me
In Randolph, fascia tends to fail first on the sides of the house where gutters clog fastest. Across Randolph and nearby communities including Dover, Wharton, Succasunna and Rockaway, the fascia under trees and heavy gutter loads is the first to go, and replacing a short section early is far easier than rebuilding the roof edge later.
Need fascia repair around Randolph? Call (973) 858-1826 for a Randolph roofer who serves the towns around it too.
How the weather here affects roofs around Randolph
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, which is how ice dams form and back water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. That is why roof repair in Randolph is busiest after a hard winter and before the next one.
Why call
Why not wait
Smaller repairs
Small roof problems caught early usually stay small repairs.
Roofers who know Randolph
Local roofers see the same roofs and storm damage across Randolph and nearby towns.
Know what happens next
Ask your questions before you agree to anything.
Common questions about fascia repair
Which fascia material lasts longest?
Primed wood, PVC, composite and aluminum-wrapped wood are the usual choices. Wood is common on older homes and works well when kept painted. No material holds up if water keeps running behind the gutter.
Do I need new fascia boards or just a repair?
Repair is fine when damage is limited to a few spots and the rafter tails are sound. If the damage is widespread, new boards end up being the simpler fix. The roofer will probe the wood to see which option fits.
Do fascia boards affect my gutters?
A gutter is only as secure as the board behind it. Soft fascia lets the fasteners work loose, which is often the first sign of rot. New fascia and new hangers together restore a solid gutter line.
Why is my fascia rotting?
Water getting behind the gutter is the main cause. A missing drip edge, clogged gutters and leaking gutter seams all keep the wood wet after every rain. Bare end grain and failed paint let water soak in faster.
Should I cover rotted fascia with metal?
Wrapping over soft fascia traps moisture and lets the rot continue unseen. Since gutters hang from the wood, the problem shows up later as a falling gutter. Replace the rotted board first, then wrap it if you want low upkeep.
More questions? Call (973) 858-1826
Often needed together
Soffit Repair
Soffit repair for wood, vinyl and aluminum eaves, before rot spreads into the fascia and rafter tails.
Learn moreGutter Installation
Seamless gutter installation sized to the roof, pitched to the downspouts and hung on hidden hangers, with the fascia checked before anything is hung.
Learn moreGutter Repair
Fixing gutters that drip at the corners, sag between hangers or pull away from the fascia, without replacing gutters that still have life in them.
Learn moreRoof Repair
Targeted roof repairs for wind, age and water damage, without replacing a roof that still has life left.
Learn more
Looking for something else?
See all roofing servicesTalk to a Randolph roofer about fascia repair
Call now for Randolph fascia repair and help in the towns around it.